Leave the panels in this location for a minimum of 48 hours before installation to allow them to acclimate.
Installing white hardboard wall panel.
Using a level mark a plumb line 48 in.
After attaching the panel to the center stud insert additional nails through all remaining studs in the same manner.
For other options like our thrifty white smooth paneling you can quickly brighten up utility and laundry rooms.
Gently remove any crown moulding baseboards and trim you plan on using again.
Stack the hardboard panels in the room where you plan to install them and leave them for 48 hours to allow them to acclimate.
In a conventionally framed room with wall studs 16 on center each 4x8 ft.
Place the first hardboard panel up to the corner of the wall and locate a wall stud in the center of it.
Thick x 4 ft.
Measure mark and cut the beadboard.
Tack a full panel in place with one long edge aligned with the plumb mark then check to see how the opposite edge fits into the corner.
It is not intended for use in a high moisture area like a shower or bathtub surround.
Use a stud sensor to locate and mark the wall framing.
Who says you can t draw on the walls.
How to install tempered hardboard panels to walls.
If the corner isn t straight and plumb you ll see gaps.
For best results set the paneling in the room for a few days before you install it.
Plan the installation to start at a left side corner and work outward across the wall to the right.
This will allow it to adjust to the humidity in a room.
Panel should end and begin on a stud.
When installing hardboard on the ceiling secure it firmly to the joists to prevent sagging.
This is the.
The first step in how to install paneling is to remove all wall plates outlets and any nails in the wall.
Panel joints may be caulked with pure white silicone sealant and panel edges fitted into extruded plastic moldings.
Measure the height of the wall where you plan to install the hardboard panels using a tape measure.
Step 1 move the hardboard panels into the installation room and lean them up against the wall with the backs facing outward toward the room.
Installation is done using a high grade panel or construction trowel on adhesive.
Insert 3 4 inch nails through the stud spacing them every 8 inches.