In most cases 4 screw nails will hold the plate firmly in place.
How to wire a garage door opener switch.
Do not confuse these terminals with the reversing photo eye terminal.
Loosen the two terminal.
Locate the bell wire that connects the wall switch to the garage door opener.
Locate the terminals on the garage door opener marked for the installation of the switch.
Place a stepladder beneath the garage door opener and unplug the power to the unit.
Once you reach the opener attach the wires to the motor terminals.
Drive a nail into jamb and wind some wire around it before running wire to the opener terminals.
The wire should be attached from the wall button to the opener motor.
Remove outlet cover locate the electrical outlet that is the nearest to your garage door opener.
Turn power off before beginning any electrical work it is always the safest option to turn the power off at the.
How to wire an electric garage door opener step 1.
Fasten wire to the key switch terminal screws before attaching mounting plate to jamb.
How to replace wall switch to a garage door opener.
Step 2 insert the low voltage wire into the terminal and press until it is fully seated.
Thread the bell wire through completed hole from inside the garage.