How To Tighten Awning Over Slide Out

Roll up topper on roller.

How to tighten awning over slide out.

Dear jim well it depends on the size and make of your slide topper. Two people will handle the awning arms one at each end while another one will feed the cord into your awning rail. It s best to have three people for this job. The awning over my slideout is sagging on one end but the other end is tight as both ends should be.

If you are satisfied move on. The slight slack allows water to puddle then as the puddle gets bigger. Step 5 re install awning. How to replace spring on awning slideout in rv adjust slide out cover how to tighten loose motorhome slideout covers tightening the spring on a slide out awning slide out kover ii how to adjust spring slide awning toppers tension adjustment how to tighten a carefree slideout topper how tochange the tension on a carefree of colorado.

Remove end cap or mount. Make sure it will not fall out. I had my slide out awnings installed by the dealer lakeshore rv. Thanks for submitting your question on our ask an rv question page.

Run slide in about 12. You do not need to put the screws back in. The roller has a spring in it. During regular use of your rv the awning fabric and slide in the awning tube causing alignment is.

If not then repeat the previous steps. In order to get the awning up and stable the tension needs to be adjusted to get the fabric taut. However perhaps someone here knows how to tighten the slide out awning. Put a cotter pin in the hole.

Roll the awning back up to observe how tight it is. How do you tighten up slideout awnings that are sagging. And i ve called and left a message still awaiting the return. Many if not most slide toppers have only one spring which is probably the side that is tight.

Just like that your awning is back in action. Usually takes 2 people. And rvs with slide outs a compartment that extends out from the main cabin providing extra living quarters are sometimes made with awnings over the slide out. Depending on the make and model there is a different method to adjust the tension.

Is there a way to adjust the tension on the end of the awning. Only rotate the legs one or two turns at a time and don t do more than 4 or 5 total. The awning over the big living room slide collects water because there is not enough tension to keep a constant slope. Different rv makers use different awning systems.

The last step is to reinstall the rv awning. Look for the pin hole near end of roller. Roller should now be free of mounting hardware. Since you do not tell me who manufactured your slideout topper awnings it will be very hard for me to tell you how to adjust the tension on them.

Here is brad taylor showing how to adjust an awning fabric.