How To Start Siding A Garage

We cover how to move doors and windows and create a weather proof exterior.

How to start siding a garage.

The nails holding one board are covered by the next one. If you are planning to paint your siding it s a good idea to prime all the pieces on all sides before installing them. Install trim under eaves rakes. Lap siding is installed upward starting at the bottom of the wall.

Once you ve decided where you want the siding to begin drive a nail through a point on your chosen starting height and snap a chalk line around the perimeter of the house. X research source nail a piece of plywood about 3 5 inches 89 mm thick along the top of the chalk line this will hold out the bottom of the first row of siding. Not just another vinyl siding installation video. Then install the corner posts that came with your siding and nail j channel along the top and bottom of the wall.

For horizontal siding install f channel trim at the soffit and gable rake. For vertical siding install j channel trim. Start with a level chalk line for the bottom starter strip and check the level periodically as you go up. At the bottoms of windows install under sill trim for horizontal siding and j channel trim for vertical siding.

If the top is mitered miter the sides as well. That way the backsides will also be protected against rot and the boards are less likely to cup or. To install vertical metal siding start by applying horizontal furring strips and sheathing to the surface you re working on if it s uneven. Install siding at the top of a window or door in a similar fashion but this time set the siding on the window channel and use the window trim to mark the cut.

This is our most comprehensive. Siding pieces snap together starting with a metal bottom strip and are nailed in place through slots at the top of the siding pieces nails should be placed in the center of those slots to allow for expansion and contraction. When installing vinyl siding on each side of a window or door start on the side that needs the longer panels. If there are any windows or doors nail j channel around the edges of those as well.